Page 11 of 12

(1).压缩空气调压阀/ pressure -regulator valve:
■调节压缩空气压力大小.调节方法是将蓝色胶旋钮向上拉起,俯视顺时针方向压力增加,反之减小,调整完
毕将旋钮按下固定即可。
Adjust the pressure of the air, the adjust method is draw the blue knob, overhead view and clockwise is
increase the pressure, conversely is reduce the pressure. Finished the adjust please depress the knob.
(2).压缩空气压力表 air pressure gauge /:
■显示压缩空气压力大小/Display the press of the air pressure.
(3).过滤器油雾器/Filter Oil Mist Separator :
■过滤压缩空气中的所有水分,杂质。为气缸加入润滑油。
Filter the water, the impurity in air pressure. Inject the lubricating oil in cylinder.
(4).快速接咀 Quick connect spur/
■压缩空气入口/The entry of air pressure。
3．开机/Starting Up
■将手拉阀推到开(ON)的位置。
Let the hand-pull valve in start (on) position.
■调整压缩空气压力至 4-6Bar 之间。
Adjust the air pressure as the press 4-6 Bar.
■插上电源插头/Plug in。
■开启电源开关/Open the power switch。
■等待几秒后，检查机器网框或印头是否已回到左边的位置，机器是否发生报警。
Wait a litter seconds, check the frame or the head print back to left position, and check the machine have
whistle or not.
Print squeegee adjust have two ways: level adjust and vertical adjust.
▲垂直调节：如下图（图 6-6）所示，用两个杯头螺丝调节印刮角度，调整到合适的角度后锁紧杯头螺丝即可。
Vertical adjust: see as the picture below (picture 6-6), use two hexagonal socket head cap screw adjust the angle
of squeegee, adjust it to the suitable angle then fixed hexagonal socket head cap screw is ok.
■印刮气压调节：为使印刮在印刷时具有一定的弹性，一般使用气压为 2-4Bar。印刮越长，压力相对加大。
Squeegee air pressure adjust: to let the print squeegee have some elasticity, usually use the air pressure
is 2-4Bar. The print squeegee more long, the press need more.
八．机械保养/Machine maintenance:
■ 机器的维护与保养,涉及多方面的管理。这里仅指出保持机器正常运行必须达到的基本要求、其它各方
11
    "