CHAPTER 15 APPENDIXES

 GYS motor (750 W)

The table below shows the cables and the connectors for the GYS motor of 750 W and the servo

amplifier.

Purchase

Type

Motor power cable

(1)

Motor power connector

(2) Power supply connector

(3) Sequence I/O cable

(4) Encoder cable

(5) DC circuit connector

Existing item can be used.

To be purchased.

Existing item can be used.

To be purchased.

Supplied with the amplifier.

WSK-M03P-F

WSK-S03P-F

WSC-P06P□□-E

WSK-R05P-F

□□: cable length

 Cable processing

servo amplifier (Frame2)

Cut here.

Connection with a GYS motor (750 W)

(1) Motor power cable

Cut the motor power cable connector

part on the amplifier side, and then

connect it to the motor power connector

for ALPHA5 Smart.

(2) Power supply cable

Cut the power supply cable connector

part for FALDIC-W, and then connect it

to the power supply connector for

ALPHA5 Smart.

(3) Sequence I/O cable

If the wiring of pulse is used with an open collector, be sure to cut the no. 7 pin (CA) and no.20 pin (CB)

on the amplifier-side connector.

(4) Encoder cable

Purchase an encoder cable for ALPHA5 Smart. Or, exchange the amplifier-side connector of the

existing encoder cable. (Exchange connector type: WSK-P06P-M)

(5) DC circuit connector

If an external regenerative resistor is used, disconnect the short-circuit wire at 3-4 terminal (RB2-RB3

terminal) and connect it to the 2-3 terminal (RB1-RB2 terminal).

Replacement (from FALDIC-W) 15-33