CHAPTER 6 KEYPAD

(21) OL thermal value (displayed digits: unsigned three digits)

on21

The load ratio to the load alarm level is displayed in

percent. An overload alarm is caused if this value reaches

ESC

SET

100. The minimum increment is 1. The displaying range is

(1 sec. or over) from 0 to 100%.

100

(22) Regenerative resistor thermal value (displayed digits: unsigned three digits)

on22

The regeneration load ratio to the regenerative resistor

overheat alarm level is displayed in percent. A regenerative

ESC

SET

resistor overheat alarm is caused if this value is 100. The

(1 sec. or over) regeneration load ratio is calculated for amplifier frame

100

no.2 or above if PA2_65 (regenerative resistor selection) is

set at 1 (internal resistor).

6

The minimum increment is 1. The displaying range is from

0 to 100%.

(23) Power (w) (displayed digits: signed three digits)

on23

The servomotor power (w) is displayed in percent to the

rating.

ESC

SET

The data is displayed in the range from 0 to 900% in

(1 sec. or over) increments of 1.

300

With a negative data

-300

(24) Motor temperature (displayed digits: unsigned three digits)

on24

The servomotor temperature is displayed. The range from

0 to 120°C is displayed in increments of 1°C.

ESC

SET

(1 sec. or over)

120

6-24 Monitor Mode