CHAPTER 3 OPERATION

(1) After the interrupt input enable signal is turned on, the activating edge

(OFF-to-ON transition) of the first interrupt input is enabled.

(2) Allocate the interrupt input to the CN1 terminal of CONT1 to 5.

Generally, the sequence input and output signals are recognized in about

1 to 2 ms by the software, however, the interrupt input detects the signals by the

hardware. Therefore, delay in signal detection (about 0.05 ms) occurs only with

the filter circuit of CONT1 to 5.

3

(3) The in-position [INP] signal shown in the figure assumes the level output mode.

Operation 3-17