CHAPTER 2 WIRING

<Logic of broadcast cancel signals>

Broadcast cancel

Broadcast

Uni-cast

No allocation

Enabled

OFF

Enabled

Enabled

Disabled

ON

Cancels the queries of broadcast,

2

without responding.

 Relevant descriptions

<Signal switching timing>

1) When switching the broadcast cancellation status between ON and OFF using the CONT

signals (CONT9 to 24) via communications, see "2. Communications timings" on page 13-27

The timing is determined based on the standard communications timing. There is no individual

timing prepared for the broadcast cancel.

2) When switching the broadcast cancel status between ON and OFF by using the CONT signals

(CONT 1 to 5) by hard signals, see the chart below. Switch the ON and OFF of broadcast cancel

under the following conditions:

(1) T1 or longer duration has elapsed after the timing the query is issued (end of telegraph), and

(2) within 2 ms before the timing the query is issued (top of telegraph).

The value "T1" corresponds to the parameter PA2_73 (Communication baud rate), and is

provided as in the table below.

Master ：

Amplifier ：

Query

Broadcast query

Query

T1

2 ms

This query is canceled.

Query

T1

2 ms

Broadcast cancel

OFF

Signal ON/OFF timing

PA2_73: Communication baud rate

0：38400 bps

1：19200 bps

2：9600 bps

3：115200 bps

T1

5 ms

10 ms

1.7 ms

Description of I/O Signals 2-59