Send Quote Requests to info@automatedpt.com
CANopen Mode
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
ASDA-A3
12.2.2.4 Synchronization object (SYNC)
12
The Synchronization objects (SYNCs) are periodically broadcast by the SYNC producer. There
is no data in the SYNC packet (L = 0).
The SYNC protocol is as follows:
SYNC producer
(controller)
Request
Write SYNC
SYNC consumer
(servo drive)
Data length (L) = 0
Indication
Indication
Indication
The SYNC object is used to achieve the synchronization of PDO transmission and reception
between the controller and servo drive. The SYNC object transmission cycle is set by the object
OD 1006h (see Section 12.4 Object dictionary for detailed settings).
The following figure shows the timing sequence between the servo drive RxPDO reception and
the controller SYNC transmission. The controller transmits RxPDO to the servo drive between
two SYNCs (communication cycle), and the servo drive will not execute the RxPDO received in
the previous communication cycle until it receives the SYNC.
SYNC
message
Communication
cycle
SYNC
message
Objects mapped in
synchronous RxPDO
Execute the
mapped objects in
the synchronous
RxPDO received
in the previous
cycle
Objects mapped in
synchronous RxPDO
Execute the
mapped objects in
the synchronous
RxPDO received
in the previous
cycle
12-12
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com