Send Quote Requests to info@automatedpt.com

Parameters

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

ASDA-A3

8

PM.020▲ Load decrease gain

Default: 100

Unit: %

Format: DEC

Applicable motor: All

Setting range: 15 to 600

Data size: 16-bit

Address: FD28H

FD29H

Settings:

This parameter setting affects the operating time of the load decrease and the overall motion planning.

Refer to the description of PM.019.

PM.021

Reserved

PM.022▲● Motor temperature sensor

Default: 0

Address: FD2CH

FD2DH

Applicable motor: Linear motor, third-party rotary motor

Unit: -

Setting range: 0 to 3

Format: DEC

Data size: 16-bit

Settings:

Sets the type of motor temperature sensor connected to the servo drive CN5 Pin 13 and Pin 14 (see

Section 3.8).

0: a motor temperature sensor is not connected

1: Delta linear motor NTC thermistor

2: NTC level thermistor

3: PTC level thermistor

Note: when PM.022 = 1, you can check the temperature by setting the monitoring variable P0.002 to -145.

PM.023

Reserved

PM.024▲ Motor temperature sensor resistance

Address: FD30H

FD31H

Default: 50000

Applicable motor: Linear motor, third-party rotary motor

Unit: ohm

Setting range: 0 to 50000

Format: DEC

Data size: 32-bit

Settings:

This parameter is only valid when PM.022 is set to 2 or 3. Set the resistance value corresponding to the

protective temperature to this parameter. Refer to the NTC or PTC temperature and resistance value

corresponding table for the resistance value.

PM.025 -

PM.027

Reserved

8-260

Send Quote Requests to info@automatedpt.com

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com