Send Quote Requests to info@automatedpt.com
ASDA-A3
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Motion Control
Macro #C - change the engagement position and operate in forward direction until the
disengagement condition is met
When the clutch is engaged, this macro immediately changes the master axis position and
automatically calculates the remaining pulse number in the cycle. When the E-Cam cycle is
complete, the clutch disengages based on the set disengagement condition (P5.088.U).
This macro can be used for setting the initial engagement position for the master axis and you
can select any of the master axis position to engage. The precision level is higher when you use
Macro #C than using P5.085 to select the section from the E-Cam table for engagement. When
using this macro, have the master axis stay stationary. Wait for the macro to complete before
operating the master axis. The operation is shown in Figure 7.3.9.1.
Slave axis position
(PUU)
Complete the
remaining cycle in
forward direction
7
Remaining
pulses in the
cycle
Default
en ga gem ent
position
P5.093
Specified
en ga gem ent
position
Figure 7.3.9.1 Macro #C operation
Master axis
position
(Pulse)
Setting steps:
1. The E-Cams engage and the master axis stops.
2. Set the disengagement condition (P5.088.U).
3. Set the engagement position: use P5.093 to write the master axis engagement position
(pulse) in hexadecimal and use monitoring variable 062 (3Eh) to monitor the current
master axis position. The range for the new specified engagement master axis position is:
P5.084
0 ≤ P5.093(Pulse) < P5.083
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
7-145