Send Quote Requests to info@automatedpt.com

Motion Control

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

ASDA-A3

7

 Cutting length is less than the E-Cam curve operating length

Reduce the E-Cam master axis pulse number and slave axis moving distance

proportionally. For example, if you reduce the master axis pulse number for each cycle

(P5.084 / P5.083) to 0.8 times of the original, the moving distance of the slave axis should

also reduce 0.8 times. You can use the E-Cam curve scaling (P5.019) to reduce the

setting by 0.8 times to shorten the cutting length. However, this method also reduces the

synchronous speed zone, so make sure that the cutting action can be completed in the

synchronous speed zone. This method is not recommended for applications when the

cutting length is greater than the E-Cam curve operating length. Because when you

increase the moving distance of the slave axis, the machine may not have sufficient

distance to complete the slave axis motion which can lead to collision.

Original cutting length

Cutting point

Cutting length

Cutting point

Cutting length

Cutting point

Speed curve

(PUU/s)

Sync. speed

zone

Dec. Reset Acc.

zone zone zone

Sync. speed

zone

Dec. Reset Acc.

zone zone zone

Sync. speed

zone

Dec. Reset

zone zone

Position

curve (PUU)

Initial lead pulse

before engaged (P5.087)

E-Cam cycle

(Reduces to 0.8 times

of the original)

Slave axis offset

(Reduces to 0.8 times

of the original)

E-Cam cycle

(Reduces to 0.8 times

of the original)

7-140

Send Quote Requests to info@automatedpt.com

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com