Send Quote Requests to info@automatedpt.com

ASDA-A3

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

Motion Control

You can use the “Speed Fitting Creation” in ASDA-Soft to create the E-Cam curve. However,

this method can only generate E-Cam curves with single operation direction. You need to create

the curves for the cutting zone and reset zone respectively. Then, combine the two curves with

the “Manually create a table” function. The operation steps are as follows:

1. Curve planning: segment the cutting zone, stop zone, and reset zone. Because the cutting

zone is in the first segment of the curve, there will be more position points plotted in the

first segment to ensure the flying shear can complete the cutting in the cutting zone. In the

following example, the cutting zone and stop zone are segmented as the first section of

the curve with 300 position points. The second section of the curve is the reset zone with

100 position points. So, the curve is composed of 400 position points.

1st section of the curve

Cutting zone

2nd section of the curve

Stop

zone

Reset zone

7

Position

curve

400 position points

300 position points

100

position

points

Send Quote Requests to info@automatedpt.com

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

7-133