Send Quote Requests to info@automatedpt.com

ASDA-A3

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

Test Operation and Panel Display

4.3.3 Alarm messages

Displayed symbol

Description

When an alarm occurs, the panel displays ‘AL’ as the alarm symbol and ‘nnn’ as

the alarm code.

Refer to Chapter 8 Parameters for a detailed description of P0.001 or Chapter 14

Troubleshooting for alarm details.

4

4.3.4 Positive and negative sign setting

Displayed symbol

Description

In Editing mode, press the UP (▲) and DOWN (▼) keys to change the displayed

value. Press the SHIFT key to change the selected value (the selected value is

flashing).

Press the SHIFT key for 2 seconds to switch between the positive (+) and

negative (-) signs. If the parameter value is out of range after the positive or

negative sign is switched, then the servo drive automatically resets it to the

original value.

4.3.5 Monitoring display

When you apply power to the drive, the display shows the monitoring symbol for one second,

and then enters Monitoring mode. In Monitoring mode, press the UP (▲) and DOWN (▼) keys

to change the monitoring variables. Or you can directly change the setting value of P0.002 to

specify the monitoring code. When the drive is powered, the default monitoring code is set to

the value of P0.002. For example, if the value of P0.002 is 4, when the drive is powered, the

panel displays the monitoring symbol C-PLS first, and then displays the input number of pulse

commands. Refer to the following table for more information. For all monitoring variables, refer

to Table 8.3 Monitoring variables descriptions in Section 8.3.

P0.002

setting value

Monitoring symbol

0

Description

Motor feedback pulse number (after the scaling of E-

Gear ratio) (user unit)

Unit

[user unit]

1

Input number of pulse commands (after the scaling of

E-Gear ratio) (user unit)

[user unit]

2

The deviation between control command pulse and

feedback pulse number (user unit)

[user unit]

3

Motor feedback pulse number (encoder unit)

[pulse]

4

Input number of pulse commands (before the scaling

of E-Gear ratio) (encoder unit)

[pulse]

5

Error pulse number (after the scaling of E-Gear ratio)

(encoder unit)

[pulse]

6

Input frequency of pulse commands

[Kpps]

4-7

Send Quote Requests to info@automatedpt.com

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com