Send Quote Requests to info@automatedpt.com

ASDA-A3

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

Wiring

3.1.7 Waterproof connector wiring instructions

3.1.7.1 F40 - F80 models – power / encoder / brake connector

CHOGORI connector

2 - 3 mm

8 - 12 mm

Step 1:

Cut through the cable and expose the

shielding. The exposed wire length should be

8 - 12 mm (0.31 - 0.47 inches) and the tinned

wire length should be 2 - 3 mm (0.08 - 0.12

inches).

(D)

(C)

(A)

(B)

Step 2:

Place the (A) seals nut, (B) seals ring,

(C) clamp ring, and (D) gasket on the cable

in sequence.

Note: place the flat face of the gasket outwards

and the groove face towards the clamp ring for the

IP67 design.

Step 3:

 For the power connector, refer to Section

3.1.4 for the pin assignment to connect

the pins.

 For the encoder connector, refer to

Section 3.1.5 for the pin assignment to

connect the pins.

(C)

(D)

Step 4:

Place the groove face of the (D) gasket

towards the clamp ring and fit it into the (C)

clamp ring.

Step 5:

Use a wrench to lock the clamp ring to the

housing and place the seals ring in the

clamp ring.

3

Step 6:

Use a wrench to lock the seals nut to the

clamp ring to complete the wiring.

Instruction on mating and unmating the CHOGORI connectors:

(2)

(1)

(2)

After wiring the CHOGORI connector, mate

the part (1) to connect the servo motor and

drive. Do not pull or rotate the (2) clamp ring

and seals nut to avoid loose connection and

Motor

Servo drive

thus fail to meet the IP67 standard.

Send Quote Requests to info@automatedpt.com

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

3-49