Page 32 of 66

connection is the laser power supply PWM input port, select PWM
mode. And according to the different laser Equipped with
ultraviolet light, optical fiber, etc. Depending on the laser
power supply is configured.
The maximum power: set the maximum output power of the laser.
Laser port maximum output power, such as setting up 50% and 50% of
the system, the power of the laser tube, namely half. This is
usually set up 100%. The limitation on the maximum power usually
does not make the request.
Shot power: set the preset percentage (some) power.
PWM frequency(FRQ): set the PWM wave frequency, please according
to the characteristics of laser Settings.
Percentage pre-excitation syndrome: setting normal power output.
Equivalent to the output power of the minimum or zero. Usually set
0%.
Shot time: set the preset (some) light time.
Coordinate:Upper left, lower left, upper right, lower right.
Import equipment parameters: will U disk parameters into the
software.
Export equipment parameters: the parameter is exported to the U
disk.
Read the equipment parameters: read the controller parameter
setting in.
Save backup: backup set current good parameters to control system
is mainly for the convenience of you here in the need to use the
last time set good parameters.
Restore: is the parameters restore to the previous backup control
system.
Sure: save the parameter Settings.
Cancellation: save the original parameter set.
    "