Page 37 of 70

Shenzhen Zhiyuan CNC Co., Ltd ZY72B8G System Manual
PWM
Hz
Configure PWM waveform frequency.
frequency
Max power percentage Set the maximum output power of the laser.
Limit the maximum output power of the
laser port, such as setting 50%, so that the
maximum power of the system is 50% of the
laser tube, which is half. This is usually set to
100%. The maximum power limit is usually
not required.
Pre
percentage Set the percentage of normal output power.
excitation
Equivalent to the minimum or zero value of
output power. Usually set to 0%
Laser
nothing If set to high level, it means outputting laser
enable level
at TTL high level; If set to low level: indicates
that the laser is output at low TTL level.
Blow mode nothing
We recommend using a high level here
Shenzhen Zhiyuan CNC Co., Ltd
32
    "