required to be fast adjust it up a bit XY process ms³ (Page 18 / 70) MorCUT-Cyclops Control System Operational Manual

Shenzhen Zhiyuan CNC Co., Ltd ZY72B8G System Manual

required to be fast, adjust it up a bit.

XY process m/s³ The rate of acceleration change during

Jerk

processing (such as cutting, drawing

brushes, etc.). This is usually done using the

default value. If it requires stability, the

acceleration should be at 60m/s ³ Up to

80m/s ³， If fast, adjust to 100m/s ³ Up to

150m/s ³。 The general system also

provides reference values, which can be

adjusted based on the system's reference

value or adjusted according to the

reference value.

Z-axis speed mm/s The speed of Z-axis idle running (feeding

speed).

XY inertia ratio

The proportion of XY acceleration,

according to which the Y-axis acceleration

is reduced (usually the Y-axis is heavier and

smaller)

3.1.2 Engraving parameters

Shenzhen Zhiyuan CNC Co., Ltd