Page 17 of 70

Shenzhen Zhiyuan CNC Co., Ltd ZY72B8G System Manual
Speed
grade 1. Low speed: The lowest speed, the most
Selection
gentle, and the best effect;
2. Normal: It is relatively faster at low
speeds, which is a common speed
configuration;
3. Faster: a relatively ordinary and faster
processing method;
4. High speed: The fastest and most
efficient speed configuration.
XY machining mm/s² The acceleration during processing (such
Acc
as cutting, drawing brushes). The
acceleration during general processing is
slightly smaller than that during idle
running, mainly to ensure better cutting
effect. Usually, the stepper motor is set to
800mm/s ² To 2000mm/s ²。 If servo is
used, adjust to 800mm/s ² To 3000mm/s
²。 Of course, this is only a reference value,
and it can be adjusted according to the
device. It can be slightly larger or smaller
than the reference range. If it is required to
be stable, adjust it down a bit, and if it is
Shenzhen Zhiyuan CNC Co., Ltd
12
    "