Portable Plasma Torch Height Controller Manual (F1620)
P02 0-50 1 50
P03 0-50 1 50
P04 0-50 1 50
P05 10-50 1 30
P06 1-10 1 1
P07 1-50 1 6
P08 0.1-9. 0.01 2
99
P09 3-20 1 5
P10 0 或
0
1
P11 0-5 1 0
P02 50
P03 50
P04 50
P05 30
P06 1
P07 6
P08 2.0
P09 5
P10 0
P11 0
Setting manual descend speed of
torch , the minimum speed is 0, the
maximum speed is 50.
CNC_THC_DN also use this speed.
Setting auto lift speed, minimum is
0,maximum is 50.
Setting auto descend speed, minimum
is 0,maximum is 50.
Unit:volt(V). The value of protecting
arc voltage. It can avoid torch descend
rapidly because of arc voltage increase
too big.
Unit:volt(V). The arc voltage precision
of adjusting. For example, setting it as
1V, if D-value between setting arc
voltage and practical arc voltage is
under 1V, it will not start auto start.
Sensitivity coefficient, the bigger
coefficient can make the sensitivity
higher. But if it is too higher,torch will
quiver around the balance location.
Unit: second(S). During torch do not
work , the time is urgency rise spear
time when torch collide the steel.
Unit: volt(V). The arc voltage value of
auto adjust. During torch work, if
torch collide the steel twice
continuously, the arc voltage value of
setting will increase this parameter
automatically.
Enabling arc voltage auto adjust.
When user set it as 1, it can allow arc
voltage to adjust automatically.
During torch work, it allow that
collision can happen several time then
make THC stop to work. When user
setting it as 0, if the collision happen is
checked by THC, it can send a
12
