B WT20C Lin Double pendulum handheld laser cleaning system
5. Check whether there is water seepage in the cavity and many waterways in the
cavity. Do not loosen screws without professional training to prevent water droplets
from entering the cavity.
6. Check whether the protective lens drawer is normal, ensure that the sealing ring is
normal and effective, when replacing the protective lens, ensure that the alcohol
wipes the external stains of the laser head, at least 5 times, and ensure that the lens
environment is clean and clean before the lens is replaced.
7. The laser head is so complex. To avoid short circuit, stay away from the water
source and make sure that no liquid can be sprayed on the laser head.
8. Laser head refuses to use strong wind to blow and clean the laser head, and can
only be wiped with alcohol and dust-free cloth.
9. The laser head is installed with a digital motor. When used, it must be put gently to
prevent motor failure.
10. When the laser head is not used, please use the system gas blowing air for many
times to discharge the dust, and remove the copper nozzle, use the sealing tape to
seal, and use the copper nozzle to blow the air for more than 2 times before using it.
11. Continuous interruption of power supply will cause damage to the welding /
cleaning control system. If the external wire transmitter, 24V power supply should
provide 200W (power voltage 24V, output current equal to or greater than 8A)!
12. The external safety lock is 24V high level, do not short connect with the aviation
plug GND shell of the system cable, or do not pay attention to collide with each
other when installation, otherwise the short circuit may burn the power supply or
35Page 24 of 27 pages37
    "