GigE Area Scan Camera User Manual

10.2.2 Enable Strobe Signal

The strobe signal is used to directly output I/O signal to external devices when the device’s

event source occurs.

Steps

1. Go to Digital IO Control → Line Source, and select Line Source according to actual

demands.

2. Enable Strobe Enable.

Figure 10-3 Enable Strobe Signal

The supported line sources are as follows:

Table 10-1 Line Source Description

Line Source

Description

Exposure Start Active

The device outputs signals to external devices when it starts

exposure.

Exposure End Active

The device outputs signals to external devices when it stops

exposure.

Acquisition Start Active The device outputs signals to external devices when it starts

acquiring images.

Acquisition Stop Active

The device outputs signals to external devices when it stops

acquiring images.

Frame Burst Start Active The device outputs signals to external devices when the

device’s frame burst starts.

Frame Burst End Active The device outputs signals to external devices when the

device’s frame burst stops.

Frame Trigger Wait

The device is currently waiting for a frame start trigger.

41