GigE Area Scan Camera User Manual

Chapter 10 Trigger Output

10.1 Select Output Signal

The device has one opto-isolated output (Line 1), and one bi-directional I/O (Line 2) that

can be configured as output signal. The steps for configuring Line 2 as output signal as

follows.

Steps

1. Go to Digital IO Control and select Line 2 as Line Selector.

2. Select Strobe as Line Mode.

Figure 10-1 Set Line 2 as Output Signal

10.2 Set Output Signal

The output signal of the device is switch signal that can be used to control external

devices such as light source, PLC, etc. There are two ways to set output signal, including

line inverter and strobe signal.

10.2.1 Enable Line Inverter

The line inverter function allows the device to invert the electrical signal level of an I/O line.

Go to Digital IO Control → Line Inverter, and enable it.

Figure 10-2 Enable Line Inverter

Note

The line inverter function is disabled by default.