GigE Area Scan Camera User Manual

13.9.3 Set User Default

You can also set default parameter by going to User Set Control, and select a user set in

User Set Default.

Note

Here we take selecting User Set 1 as an example.

Figure 13-20 Set User Default

13.10 Multicast Function

The multicast function enables multiple PCs to access the same device at the same time.

At the same time, the same device can only be connected by one client in controller and

data receiver mode or controller mode, but can be connected by multiple clients in data

receiver mode. The multicast mode of each device within the client is controlled

individually. The description of three multicast modes is shown below.

Table 13-7 Multicast Mode Description

Multicast Mode

Description

Controller and Data

Receiver

This mode allows you to read and edit the device’s

parameters, and get its image data.

Controller

This mode allows you to read and edit the device’s

parameters, but you cannot get its image data.

Data Receiver

This mode allows you read the device’s parameters and get

its image data, but you cannot edit its parameters.

When the multicast function is enabled, the device icon on the client software of other PCs

will become

, and you can connect the device via the data receiver mode.

You can set multicast function for both the available device and connected device in the

device list, but the specific settings are different.

13.10.1 Set Multicast (Available Status)

Follow steps below to set multicast function if the device is in available status.

Steps

1. Right click the available device, and click Multicast Settings.

107