成都兴多维科技有限公司

Chengdu multidimensional robotization technology company

if it is multi-spindle, this parameter is the current tool relative

to the workpiece origin Y-axis coordinate offset. The remaining set

of tool Y-axis position offsets are the same.

31013：No. 1 knife Z position offset No. 1 knife X position

offset; if it is a tool change, the parameter value is the Z axis

coordinate of the position of the tool magazine; if it is multi-

spindle, this parameter is the current tool relative to the workpiece

origin Z-axis coordinate offset. The remaining group tool Z-axis

position offset is the same.

7.6 Spindle parameter

This column parameter can set the spindle speed, control mode,

spindle open delay and so on.

20001：Maximum spindle speed; maximum speed allowed by the

spindle.

20002：The default speed of the spindle; the default speed of the

spindle must be the same as the inverter setting.

20003：Spindle start delay; after the spindle receives the start

signal, it takes a while to reach the specified speed. During this

period, it is necessary to wait for a period of time, which is the

spindle start delay. Change the software wait time by changing this

parameter.

20004：Spindle off delay; after the spindle receives the shutdown

signal, it takes a period of time to completely stop. This period of

time is called the spindle off delay. Change the software to wait for

the spindle to close by changing this parameter.

兴于思 维至精

146