成都兴多维科技有限公司

Chengdu multidimensional robotization technology company

6.5.3 Tool Setting

The CNCRouter system supports two tool setting modes: floating

tool setting and fixed tool setting. The user can change the

parameter 30201 tool setting mode and select the corresponding mode.

Before setting the tool, you need to set the thickness of the

tool 30202. The correct calculation of the parameter software can

calculate the workpiece origin normally. In the floating tool setting

mode, only the tool setting position Z is required; in the fixed tool

setting mode, the tool setting position X, Y is also required. The

tool setting position Z is the position where the positioning of the

tool is started.

The interface user can set the workpiece software below, move the

tool to the workpiece origin, and click [X Zero], [Y Clear], [Z

Clear] to complete the workpiece origin setting. Click the [Floating

Tool Set] / [Fixed Tool Set], [First Time Pair], [Tool Change After

Tool Change] to perform the corresponding tool setting operation.

6.5.3.1 Floating tool

The floating tool setting process is shown in Figure 5.4-1. Move

it manually to the top of the tool block and click [Load Current Z

Coordinate]. This position is the Z-axis coordinate at which the tool

is fine-tuned. Click on the floating tool setting. At this point, the

tool is started. When the spindle is lowered to this position, the

tool touches the tool setting tool at a slow speed. When the tool is

touched, the software gets a signal. The software automatically

calculates the Z-axis coordinate of the workpiece surface and sets it

as the workpiece origin coordinate. The Z-axis is pulled up to

complete the tool setting.

兴于思 维至精

120