成都兴多维科技有限公司

Chengdu multidimensional robotization technology company

6.3.4 Marker Assignment

In some extreme cases, the coordinates of each Mark point can be

entered manually when the camera recognition condition cannot be met.

The software will omit the process of recognizing the Mark point by

the patrol edge, and perform the offset calculation based on the

manually input Mark point coordinates.

For marking convenience, the user is allowed to move the lens to

the target and record the current position. Manually control the

moving head through the machine control interface to ensure that the

green cross in the view coincides with the center of the circle. If

the error is large during this operation, it will cause the problem

of inaccurate cutting position during processing.

After the center of the green cross is coincident with the center

of the circle, click [Load] below to try to record the position of

the measuring point. On the left side, you can view the X and Y axis

coordinates of the marked point. Check the rear [Specify], the system

will use this coordinate as the position coordinate of the

corresponding point; if it is not checked, it will not be used.

After setting each point position, click [CCD Processing], the

machine will process at this moment, and the machine will not process

the identification directly. Subsequent processing control is exactly

the same as CCD patrol processing.

兴于思 维至精

114