ACD320 user manual
Parameter Description
Function Code
Name
Setting Range
Default
Value
F1.06
Motor stator
resistance
0.00165.535Ω
Set by
model
F1.07
Motor rotor
resistance
0.00165.535Ω
Set by
mode
F1.08
Motor stator/rotor
inductance
0.16553.5mH
Set by
mode
F1.09
Mutual inductance of
motor stator/rotor
0.16553.5mH
Set by
mode
F1.10
No-load current
0.01655.35A
Set by
mode
After the motor self-learning is normally ended, F1.06-F1.10 setting values are
automatically replaced. These parameters are the basis of high performance vector control and
have direct effect on the control performance.
Important: users DO NOT change this group parameters at will.
Function Code
Name
Setting Range
Default
Value
0:NOoperation
1: complete tuning
Self-learning of motor
F1.11
Self-learning
0
parameters
2: static tuning
Self-learning
Note:This function is invalid for ACD200Seriess.
0: NO operation, forbidding self-learning.
1: self-learning of parameters
Prior to parameters self-learning, the motor must be disconnected with its load-ensuring the
motor at no-load condition, and confirming the motor is at static state.
Prior to parameters self-learning, it is a must to correctly input the motor nameplate
parameters(F1.01~F1.05), otherwise what is self learned about motor parameters may be not
correct.
Prior to parameters self-learning, theAcceleration and Deceleration time (F0.08 and F0.09)
should be set properly based on the motor inertia, otherwise over current fault may happen
during motor parameters self-learning.
When the self-learning of motor parameters is started by setting F1.11 as 1 and then pushing
the button FUNC/DATA, LED displays -TUN- and flickering, then push the button RUN to
- 65-
    "