B.3.1.2 PG-02 Terminal Descriptions

1. Terminals

Appendix B Accessories|VFD-B Series

Terminal Symbols

Descriptions

Power source of PG-02 (FSW1 can be switched to 12V or 5V)

VP

Output Voltage: (+12VDC ±5% 200mA) or (+5VDC ±2% 400mA)

DCM

A- A ，B- B

A/O, B/O

Power source (VP) and input signal (A, B) common

Input signal from Pulse Generator. Input type is selected by FSW2. It

can be 1-phase or 2-phase input. Maximum 500kP/sec (z-phase

function is reserved). If the voltage exceeds 12V, it needs to use TP

type with connecting the external current limiting resistor(R). The

current should be within 5 to 15mA.

The formal of current limiting resistor is:

5mA ≤ Vin − 2V ≤ 15mA

480Ω + R

PG-02 output signal for use with RPM Meter. (Open Collector)

Maximum DC24V 100mA

COM

PG-02 output signal (A/O, B/O) common.

2. Wiring Notes

The control, power supply and motor leads must be laid separately. They must not be fed

through the same cable conduit / trunk.

a. Please use a shielded cable to prevent interference. Do not run control wires

parallel to any high voltage AC power line (220 V and above).

b. Connect shielded wire to DCM only.

c. Recommended wire size 0.21 to 0.81mm2 (AWG24 to AWG18).

d. Wire length:

Types of Pulse

Generators

Maximum Wire Length

Wire Gauge

Output Voltage

50m

Open Collector

Line Driver

Complementary

50m

300m

70m

1.25mm2 (AWG16) or above

Revision July 2008, BE16, SW V4.08 & V5.00

B-23