Position of the sensors
The sensor unit
The various sensors are identified by the number shown on the cable marking label; danger
of damage to moving parts if sensors are swapped over.
The sensors are pre-assembled in calibrated bushes to allow simple insertion to the right depth in the
electrospindle.
It is therefore important to correctly identify the sensor to be replaced: for this reason, both the sensors
installed on the electrospindle and those supplied as spare parts bear a numbered cable marking hose
clamp.
Sensor Unit
1 Electrical connector
2 Cable marking label
3 Bush and sensor
L Calibrated position
e Eccentricity for adjustment
4 sensor
5 Sensor blocking bracket
6 Embedded hexagon screw
38
