REPLACING COMPONENTS
Only qualified and authorized personnel can take off and replace the components.
Potential
Danger
Inside the electrospindle there is a pre-loaded spring with a force of
several hundred kilograms. This spring is attached to a tie-rod that may
fly out violently if the electrospindle is dismantled by personnel who
have not been sufficiently trained.
Carry out only the operations described in this manual, paying close
attention to the instructions given; if in doubt, contact the Assistance
Service of CCMOTOR.
All removal and reload operations must be carried out under the following conditions:
Absolutely ensure that the machine has stopped, the power switch control board has
been disconnected, the switch has been locked, and the maintenance manager has key
in the hand. Make sure that the tool has completely stopped rotating.
Replace with all the necessary tools and equipment. Make sure there is no potential
danger. All spare parts have been cleaned, and the grease and lubricant has been
removed in accordance with the requirements.
Use only original spare parts and replace according to the instructions in this manual.
No other adjustment should be done on the electrospindle, which will result in the failure
of our guarantee.
34
